BF flotation cell has two types: type I and type II. Type I is improved as suction cell referring to model SF; type II is improved as direct flow cell referring to model JJF.
Each feeding inlet of Xinhai cyclone unit is installed knife gate valve independently developed by Xinhai. This valve with small dimension reduces the diameter of cyclone unit.
The supports at both ends of cone crusher main shaft, scientific design of crushing chamber, double insurance control of hydraulic and lubricating system.
Wet type overflow ball mill is lined with Xinhai wear-resistant rubber sheet with excellent wear resistance, long service life and convenient maintenance
Wet type grid ball mill is lined with Xinhai wear-resistant rubber sheet with excellent wear resistance design, long service life and convenient maintenance.
Ring groove rivets connection, plate type screen box, advanced structure, strong and durable Vibration exciter with eccentric shaft and eccentric block, high screening efficiency, large capacity
Xinhai improves the traditional specification of crushing chamber by adopting high speed swing jaw and cambered jaw plate.
High-speed hammer impacts materials to crush materials. There are two ways of crushing (Wet and dry)
The cone slide valve is adopted; the failure rate is reduced by 80%; low energy consumption;the separation of different material, improvement of the processing capacity by more than 35%.
Cylindrical energy saving grid ball mill is lined grooved ring plate which increases the contact surface of ball and ore and strengthens the grinding.
20-30%. Rolling bearings replace slipping bearings to reduce friction; easy to start; energy saving 20-30%
Both sides of the impeller with back rake blades ensures double circulating of slurry inside the flotation tank. Forward type tank, small dead end, fast foam movement
practical range of classification for cyclones inlet nozzle at the point of entry into the feed vortex finder is to control both the separation .. Involuted Feed.
Dec 11, 2009 validation are the feed pressure vs feed flow rate and recovery to underflow INTRODUCTION. Cyclone separators are used extensively to classify classifying cyclone with involute entry whereas the DSM is the typical short
The Gmax 2 inch cyclone has a typical separation range for particles of 15 microns in size. These cyclones feature involuted feed entry into the cyclone, which
Xinhai hydrocyclone with unique involute feeding reduces wear and makes a smooth movement of liquid inside cyclone, therefore gives a sharp classification. particles or light phase from the overflow tube, so as to achieve separation.
or more simply Cyclones, and variations such as McLanahan Separators™ are are typically a cono-cylindrical shape with either a tangential or involute feed
With KREBS separation systems its easy to see . upon the Krebs original involute style feed inlet that was the state of the art sensing and communications to Krebs cyclone separator products. . parts -- often within 24 hours. In addition to
Feb 10, 2007 All these developed models will only applicable to low feed solid . modelling cyclone separators. . An involute creates less radial velocity.
1993-2018 Xinhai Machine . All rights reserved | Design by Xinhai